Cylinder block
engine, front
Required: 1
original brass type - 1/2"-20 UNF thread
TR5/250, TR6 Carburettor to CC32142, TR6 P.I. to CP26998
Required: 1
wing type made from steel - with 9/16" BSP thread
TR6 Carburettor from CC50001, TR6 P.I. from CP50001
Required: 1
steel type
TR6 Carburettor from CC50001, TR6 P.I. from CP50001
Required: 1
engine, rear
Required: 1
front - steel
TR5/250, TR6 Carburettor to CF35000, all TR6 P.I.
Required: 1
front - lightweight alloy replacement
TR5/250, TR6 Carburettor to CF35000, all TR6 P.I.
Required: 1
front - steel
TR6 Carburettor to CF35001
Required: 1
oil gallery - supplied in a stick of 9. Cylinder block, front side
Required: 1
for oil pressure relief valve, uprated version allows working pressure of 75 to 85 PSI. For all cars with genuine or uprated oil pump. Highly recommended when an oil cooler is fitted
Required: 1
1 plug connection, for warning light - OE type
TR5/250, TR6 Carburettor to CC85737, all TR6 P.I.
Required: 1
2 plug connection, for warning light - uprated to 20 PSI
TR5/250, TR6 Carburettor to CC85737, all TR6 P.I.
Required: 1
3 plug connection - for warning light and anti run-on valve
TR6 Carburettor from CF1
Required: 1
for fuel pump aperture in cylinder block
P.I. models, Carburettor models when replacing the mechanical pump with a electric unit
Required: 1
mechanical fuel pump resp. blanking plate to cylinder block
Required: 2
cup type - rear of cylinder block
Diameter: 1.1/4"
Required: 1
rear - steel
Required: 1
oil seal - in rear engine plate
Required: 1
top centre bolt only
Oil seal housing to cylinder block
Required: 1
Dirko HT red
Recommended for the installation of gaskets
Required: 1
Content: 70 ml (€185.57 / 1000 ml)
matt black
Required: 2
Content: 400 ml (€32.48 / 1000 ml)