Cylinder head
for 594cc engines. Bare head less valves and springs - reconditioned, in exchange
126, 1st Series (1972-76)
Required: 1
for 650cc engines. Bare head less valves and springs - reconditioned, in exchange
126, 2nd Series (1977-87)
Required: 1
square variant for 650cc engines . Bare head with spark plug sleeves but less valves and springs - reconditioned, in exchange
126, 2nd Series: German models only (1977-87)
Required: 1
classic sheet metal gasket with 0.8 mm thickness - for 594cc engines
126, 1st Series (1972-76)
Required: 1
tin gasket with 0.8 mm thickness - for 650cc engines
126, 2nd Series (1977-87)
Required: 1
with tin head gasket with 0.8 mm thickness - for 594cc engines
126, 1st Series (1972-76)
Required: 1
with tin head gasket with 0.8 mm thickness - for 650cc engines
126, 2nd Series (1977-87)
Required: 1
to fix rocker arm adjusting screw - identified by M7 thread
Required: 4
rocker shaft
Required: 2
+0.05 mm oversize
Required: 4
+0.10 mm oversize
Required: 4
outer spring for exhaust valve with triple groove valve stem
Required: 2
outer spring for inlet and exhaust valve with single groove valve stem
Required: 4
with 32 mm head diameter and valve stem with single groove
Required: 2
with 28 mm head diameter and valve stem with three grooves
Required: 2
with 28 mm head diameter and valve stem with single groove
Required: 2
for inlet and exhaust valves - standard size with 14.06 mm outer diameter. Steel type
Required: 4
for inlet and exhaust valves - over size with 14.27 mm outer diameter. Steel type
Required: 4
inside breather hose
Required: 1
cylinder head - 8 piece kit plus with nuts and washers - bolt length: 210 mm
Required: 1
cylinder head
Carbon Monoxide (CO) Safety Screw The air-cooled Fiat models 500 and 126 use the cooling air directly for heating. To prevent passengers from being poisoned with carbon monoxide unnoticed in the event of a defect in the cylinder head gasket, a duct directs the contaminated air out through a hollow screw with a whistling sound. This vent screw has a double function as a fastening element for the thermostat housing. Unfortunately, in many cars the hollow screw is replaced with a standard M8 bolt. In the event of damage to the cylinder head gasket, this is life-threatening for the driver and passengers! Make sure that your vehicle is fitted with the original CO safety screw.
Required: 1
